Underweighting can be just as dangerous as overweighting.

scuba diver in lotus position

Equipment and the Environment Will Both Affect Your Buoyancy

Wetsuits, tanks, and even accessories and tools will affect your buoyancy. Whenever you change one of these items, it is necessary to complete a buoyancy check to determine the effect of the new item on your buoyancy. The salinity of the water will also affect a divers buoyancy. The obvious example is buoyancy in fresh water vs salt water, but keep in mind that the salinity of the ocean may also vary in different regions of the world, and you may need slightly more or less weight depending upon your dive location.

Conducting a weight test before a dive can make the difference between a miserable dive and an enjoyable one.

 

Conduct a Buoyancy Check Before DivingScuba 2

Test your buoyancy in a new location or whenever diving with a new piece of gear. Most of the time, diver’s have a limited number of dives on vacation, and it is worth the effort to make every dive comfortable and safe.

In fact, most dive operators will be thrilled if you ask to wade into the ocean or hop of the pier before your first dive to double check your weighting.

 

The general rule of thumb for proper weighting is that with all of his gear in place, with a nearly empty tank, a diver who completely empties his BCD and holds a normal breath should float at eye level. When he exhales he should sink.

 

Remember!! As the tank empties, it will become positively buoyant.

If you can empty your BCD, hold a normal breath, and float at eye level at the beginning of the dive, you will not have enough weight to comfortably maintain neutral buoyancy at the end of the dive.

The problem here is that most dive shops are not in the practice of providing nearly empty tanks for buoyancy tests. There are two solutions to this:

 

  1. Conduct the buoyancy test with a full tank as outlined above, and then add the appropriate amount of weight to offset the buoyancy swing of your tank as it empties.
  2. Conduct the buoyancy test as outlined above with a full tank, but instead of checking that you float at eye level, check to see that you sink slowly while holding a normal breath.

 

Double Check Your Buoyancy at the End of a Dive

Once you have successfully completed a dive with enough weight to keep you comfortably below water the entire time, it is a good idea to double check your weighting at the end of the dive.

To do this, purge your regulator gently until you are down to about 500 psi or 30 bar. Then, on the surface, conduct a buoyancy check before exiting the water. Do you float at eye level and sink when you exhale?Scuba 3

Do you have to swim to get down? Float like a balloon on the surface? Add a little weight on your next dive.

Do you still sink while holding your breath? Remove a few pounds and try again on the next dive.

 

Adding a Small Amount of Air to Your BCD During Descent Is Good

Many divers seem pleased that they can descend and arrive at the planned depth without adding air to the BCD.

Again, this is not a desirable situation. Because most tanks become more positively buoyant throughout a dive, divers who do not need to add air to their BCDs during descent to establish neutral buoyancy are likely to be underweighted.

 

I Don’t Need to Add Air During Descent. I Am Fine at the End of the Dive!

These are the people who have exceptionally low air consumption rates, and surface with at least half of their air remaining. Yes, they can be perfectly neutral during their safety stops, and they don’t go flying to the surface like awkward buoys at the end of the dive. Their tanks have not become positively buoyant because they haven’t breathed enough gas to cause a buoyancy swing.

 

The problem with this habit is that it does not prepare divers for an emergency situation, when they are low on gas because they over-breathed a tank due to a stressful situation, surface with less gas than normal due to an unforeseen occurrence, or are forced to share air with another diver.

In these situations, such a diver will have trouble staying down, and of course, these are the situations when having enough weight can make a big difference between an annoying situation and an uncontrolled ascent to the surface.

Plan for the worst case scenario: a low tank and increased breathing rates due to stress.

 

Diving with less weight does not make you a better diver.

Diving with the correct amount of weight does.

Slight overweighting is correctable: just add a little air to the BCD.

To be safe on dives, proper weighting is key.

Take the time to get your weighting right and you can avoid many potentially dangerous situations and dive more comfortably.